Bosu Ball Cable Crunch With Side Bends

Séquence

1. 01 · setup

   Connect a standard handle to each arm of a cable machine, and position them in the most downward position.

2. 02 · ball placement

   Grab a Bosu Ball and position it in front and center of the cable machine.

3. 03 · lie back

   Lie down on the Bosu Ball with the small of your back arched around the ball. Your rear end should be close to the floor without touching it.

4. 04 · grab handles

   With both hands, reach back and grab the handle of each cable.

5. 05 · start position

   With your feet positioned in a wide stance, extend your arms straight out in front of you and in between your knees. Your hands should be at knee level.

6. 06 · crunch up

   Keep your arms straight and in-line with the upward angle of the cable. Elevate your torso in a crunching motion without dropping or bending your arms.

7. 07 · lower

   Maintain the rigid position with your arms. Slowly descend back to the starting position with your back arched around the Bosu Ball and your abdominals elongated.

8. 08 · repeat

   Repeat the same series of movements to failure.

9. 09 · plank switch

   Once you reach failure, keep your abs tight and raise your torso into plank position so your back is elevated off the Bosu Ball.

10. 10 · side bends

    Lower your arms down to your side; keep them straight. Start doing alternating side bends; reach for your heels! This finishing movement will focus on your obliques.