Squat With Plate Movers

Séquence

1. 01 · setup

   To begin, first set the bar on a rack to just below shoulder level. Position a weight plate on the ground a couple feet back from the rack. Once the bar is loaded, step under it and place the back of your shoulders across it.

2. 02 · unrack

   Hold on to the bar with both hands and lift it off the rack by first pushing with your legs and at the same time straighten your torso.

3. 03 · stance

   Step away from the rack and adopt a wide stance with the toes slightly pointed out, with one foot on the weight plate. Keep your head up at all times. This will be your starting position.

4. 04 · descend

   Begin to slowly lower the bar by bending the knees and hips. Continue down until the angle between the upper leg and the calves becomes slightly less than 90-degrees.

5. 05 · drive up

   Raise the bar as you exhale by pushing the floor with the heels of your feet as you extend the hips and knees.

6. 06 · side step

   At the top of the movement, side step, bringing your feet together on the opposite side of the plate.

7. 07 · push plate

   Using your inside foot, push the weight plate, sliding it across the floor to where you were just standing.

8. 08 · reset

   Place your inside foot on the weight plate, adopting a wide stance for the next repetition.